CZPT Tape Winding CZPT for Hydro-generator Coil Bar Insulation Tape

Specification

1,Managed and operated by Computer

2,One cylinder higher and 1 cylinder reduce every single at two ends, change the coil bar to bandage at the exact same horizontal level

three,There are 4 cylinders in the center, maintain the coil bar immediately in accordance to the duration of its straight part

four,Use one electrical motor, which drives the gear box to rotate one particular cycle for a journey of twelve.55mm, precision±0.05mm (125.five~126.5mm for each

ten cycles)

five,Tape width 25mm, fifty percent overlapping, double taping, distance among two pieces six.25mm, ±0.75mm

6,Taping velocity: fifty~200r/min, stepless adjustable by frequency invertor, max. speed: 220r/min

seven,Max. taping area: 30×70mm2

8,Duration of the straight part: steplessly adjustable in between (900~2000mm), (900~3000mm), with double equipment explorator of diverse

length

nine,Size of stop component to be taped: 650mm, complete length to be taped: 3300mm

ten,Middle height of the taping head: 1400mm (the consumer could use a foot board since the centre top are unable to be reduced thanks to the height

of the cylinder)

11,Coil bar to be clamped by manual procedure at finish component

12,Taping can adhere to the bend of the coil (angle of the bend between 28~43°), there are four pcs. of arc gears for trade, the taping

velocity will lessen immediately at the arc to insure the taping high quality

13,Two direction modes available: both the coil sales opportunities in very same direction and in reverse route.